STOCK IMAGE
Auction Ended
2 Truck Upfitters Gas Props for Undercover Tonneau Covers ONLY. 27.5" Extended and 15.6" Compressed Length (Measured from Center of Ball mounts), 38 pounds of Pressure ea. Incl 4 Ball mounts!
Sold
Good Condition
QTY 1
$1.00
MSRP
MSRP is a sample online retail price.
$29.99
Last Update:
04/19/2025, 10:49 PM ESTItem Information
MSRP:
MSRP is a sample online retail price.
$29.99
Brand:
Truck Upfitters
Condition:
Good Condition
Description:
Truck Upfitters Premium Gas Struts for Undercover Style Tonneau Covers (SE, Classic, Elite models) ONLY. These do NOT fit any other brand tonneau covers. Also, these do NOT fit the Ford Sport Trac Undercover Tonneau. Please measure your struts, from center of ball mount to center of ball mount, before replacing with these. Will NOT fit any fiberglass or any other brand tonneaus and lids. INSTALLATION INSTRUCTIONS: 1. All gas lift spring CANNOT be compressed by hand, so please do not think they are defective because the won't close using hand/arm pressure. A LOT of pressure is required to compress these props! 2. All undercover series gas spring need to be installed in the OPEN / EXTENDED position, so please do not try to compress and install them in the compressed position. Therefore, open your door to ensure your mounted props are EXTENDED. 3. VERY IMPORTANT: Use another person's help (or 2 people for heavier doors) to hold the door in the extended position while you remove the old gas lift shocks. Do NOT use a broomstick or any other device to hold the door open while you remove the prop. it may fall & cause you or your vehicle serious damage. 4.To remove your old gas prop, use a small screwdriver to lift up on the retaining band, then pull the gas prop end away from the mount. You do not need to remove the retaining metal band, just lift it away from the nylon head enough to allow the head to come off. 5. To install, place the replacement gas struts so that the wide (black part) of the gas prop (the body) is on the top, and the shaft (silver part) is on the bottom when the door is in the closed/resting position. This is so that the oil in the body will keep the seal wet, preventing it from cracking & allowing all of the pre- charged air out, resulting in failure. After aligning properly, press the nylon end head of each shock onto the 10mm ball mount. You will NOT need to lift up on the band to install.
Model:
Truck Upfitters
Lot Code:
TEA2230477
Width:
2.2 inches
Depth:
1.0 inches
Weight:
1.8 pounds
Length:
31.4 inches
Additional Info:
Good Condition
Pickup Location:
967 Goodale Blvd, Columbus OH 43212
Auction Number
GDB2500555
